Cisco Nexus 5600 Series - Enabling CFS to Distribute NTP Configurations

PurposeCommand or Action
(Optional)
Saves the change persistently through reboots and
restarts by copying the running configuration to the
startup configuration.
switch(config)# copy running-config
startup config
Step 4
This example shows how to enable CFS to distribute IVR configurations:
switch(config)# ivr distribute
switch(config)# show cfs application
----------------------------------------------
Application Enabled Scope
----------------------------------------------
ivr Yes Physical-fc
switch(config)# copy running-config startup-config
[########################################] 100%
Enabling CFS to Distribute NTP Configurations
You can enable CFS to distribute NTP configurations to all Cisco NX-OS devices in the network.
Before You Begin
Make sure that you enable the NTP feature (using the feature ntp command).
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Enables CFS to distribute NTP configuration updates.switch(config)# ntp distribute
Step 2
(Optional)
For the specified application, displays the CFS
distribution status.
switch(config)# show application-name
status
Step 3
(Optional)
Saves the change persistently through reboots and
restarts by copying the running configuration to the
startup configuration.
switch(config)# copy running-config
startup config
Step 4
switch# configure terminal
switch(config)# ntp distribute
switch(config)# show ntp status
Distribution : Enabled
switch(config)# copy running-config startup-config
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
OL-31641-01 55
Using Cisco Fabric Services
Enabling CFS to Distribute NTP Configurations