Cisco Nexus 5600 Series - Enabling One-Time Authentication for SNMP over TCP; Assigning SNMP Switch Contact and Location Information; Configuring the Context to Network Entity Mapping

Enabling One-Time Authentication for SNMP over TCP
You can enable a one-time authentication for SNMP over a TCP session.
PurposeCommand
Enables a one-time authentication for SNMP over a
TCP session. This feature is disabled by default.
switch(config)# snmp-server tcp-session [auth]
Assigning SNMP Switch Contact and Location Information
You can assign the switch contact information, which is limited to 32 characters (without spaces), and the
switch location.
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configuration terminal
Step 1
Configures sysContact, the SNMP contact name.switch(config)# snmp-server contact
name
Step 2
Configures sysLocation, the SNMP location.switch(config)# snmp-server location
name
Step 3
(Optional)
Displays information about one or more
destination profiles.
switch# show snmp
Step 4
(Optional)
Saves this configuration change.
switch# copy running-config
startup-config
Step 5
Configuring the Context to Network Entity Mapping
You can configure an SNMP context to map to a logical network entity, such as a protocol instance or VRF.
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configuration terminal
Step 1
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
OL-31641-01 165
Configuring SNMP
Enabling One-Time Authentication for SNMP over TCP