Cisco Nexus 5600 Series - Verifying the Netflow Configuration

PurposeCommand or Action
Sets the flush timeout value in seconds. The
range is from 5 to 60 seconds.
flow timeoutseconds
Example:
switch(config)# flow timeout 30
Step 2
(Optional)
Saves the change persistently through reboots
and restarts by copying the running configuration
to the startup configuration.
copy running-config startup-config
Example:
switch(config)# copy running-config
startup-config
Step 3
Verifying the NetFlow Configuration
To display the NetFlow configuration, perform one of the following tasks:
PurposeCommand
Displays information about NetFlow flow exporters
and statistics. You can enter up to 63 alphanumeric
characters for the flow exporter name.
show flow exporter [name]
Displays information about NetFlow interfaces.
show flow interface [interface-type slot/port]
Displays information about NetFlow flow records.
You can enter up to 63 alphanumeric characters for
the flow record name.
show flow record [name]
Displays information about the Layer 2 NetFlow
configuration.
show flow record netflow layer2-switched input
Displays information about NetFlow timeouts.show flow timeout
Displays information about NetFlow samplers.
You can enter up to 63 alphanumeric characters for
the sampler name.
show sampler [name]
Displays information about NetFlow hardware IP
flows.
show hardware ip flow
Displays the NetFlow configuration that is currently
on your device.
show running-config netflow
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
274 OL-31641-01
Configuring NetFlow
Verifying the NetFlow Configuration