Cisco Nexus 5600 Series - Displaying the Switch Profile Synchronization between Local and Peer Switches

set qos-group 3
system qos
service-policy type qos input p1
vlan 2-50
interface port-channel10
switchport mode trunk
vpc 1
switchport trunk allowed vlan 1,10-50
interface port-channel100
switchport mode trunk
vpc peer-link
switch(config-sync)#
Displaying the Switch Profile Synchronization Between Local and Peer
Switches
This example shows how to display the synchronization status for two peer switches:
switch1# show switch-profile sp status
Start-time: 491815 usecs after Thu Aug 12 11:54:51 2010
End-time: 449475 usecs after Thu Aug 12 11:54:58 2010
Profile-Revision: 1
Session-type: Initial-Exchange
Peer-triggered: No
Profile-status: Sync Success
Local information:
----------------
Status: Commit Success
Error(s):
Peer information:
----------------
IP-address: 10.193.194.52
Sync-status: In Sync.
Status: Commit Success
Error(s):
switch1#
switch2# show switch-profile sp status
Start-time: 503194 usecs after Thu Aug 12 11:54:51 2010
End-time: 532989 usecs after Thu Aug 12 11:54:58 2010
Profile-Revision: 1
Session-type: Initial-Exchange
Peer-triggered: Yes
Profile-status: Sync Success
Local information:
----------------
Status: Commit Success
Error(s):
Peer information:
----------------
IP-address: 10.193.194.51
Sync-status: In Sync.
Status: Commit Success
Error(s):
switch2#
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
OL-31641-01 27
Configuring Switch Profiles
Displaying the Switch Profile Synchronization Between Local and Peer Switches