Cisco Nexus 5600 Series - Importing Configurations in a Vpc Topology

switch(config-sync-sp-import)#
switch(config-sync-sp-import)# show switch-profile buffer
switch-profile : sp
----------------------------------------------------------
Seq-no Command
----------------------------------------------------------
3 vlan 100-299
4 vlan 300
4.1 state suspend
5 vlan 301-345
6 interface port-channel100
6.1 spanning-tree port type network
7 interface port-channel105
switch(config-sync-sp-import)#
Importing Configurations in a vPC Topology
You can import configurations in a two-switch vPC topology.
For specific information about the following steps, see the appropriate sections in this chapter.Note
1
Configure the switch profile with the same name on both switches.
2
Import the configurations to both switches independently.
Ensure that the configuration moved to the switch profile on both switches is identical; otherwise, a
merge-check failure might occur.
Note
3
Configure the switches by entering the sync-peer destination command.
4
Verify that the switch profiles are the same by entering the appropriate show commands.
Verifying Commands in a Switch Profile
You can verify the commands that are included in a switch profile by entering the verify command in switch
profile mode.
Procedure
PurposeCommand or Action
Enters configuration synchronization mode.config sync
Example:
switch# config sync
switch(config-sync)#
Step 1
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
OL-31641-01 19
Configuring Switch Profiles
Importing Configurations in a vPC Topology