Cisco Nexus 5600 Series - Configuring Link Notifications

Related CommandsMIB
snmp-server enable traps zone
snmp-server enable traps zone
default-zone-behavior-change
snmp-server enable traps zone
enhanced-zone-db-change
snmp-server enable traps zone merge-failure
snmp-server enable traps zone merge-success
snmp-server enable traps zone request-reject
snmp-server enable traps zone unsupp-mem
CISCO-ZS-MIB
snmp-server enable traps configCISCO-CONFIG-MAN-MIB
Supports no MIB objects except the
following notification:
ccmCLIRunningConfigChanged
Note
The license notifications are enabled by default.Note
To enable the specified notification in the global configuration mode, perform one of the following tasks:
PurposeCommand
Enables all SNMP notifications.switch(config)# snmp-server enable traps
Enables the AAA SNMP notifications.switch(config)# snmp-server enable traps aaa
[server-state-change]
Enables the ENTITY-MIB SNMP notifications.switch(config)# snmp-server enable traps entity
[fru]
Enables the license SNMP notification.switch(config)# snmp-server enable traps license
Enables the port security SNMP notifications.switch(config)# snmp-server enable traps
port-security
Enables the SNMP agent notifications.switch(config)# snmp-server enable traps snmp
[authentication]
Configuring Link Notifications
You can configure which linkUp/linkDown notifications to enable on a device. You can enable the following
types of linkUp/linkDown notifications:
• cieLinkDown—Enables the Cisco extended link state down notification.
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
OL-31641-01 163
Configuring SNMP
Configuring Link Notifications