Cisco Nexus 5600 Series - Configuring ACL Logging; Information about ACL Logging

PurposeCommand
Displays detailed information about the IP access list
cache.
show logging ip access-list cache detail
Displays the status of the IP access list cache.show logging ip access-list status
Displays the last number of lines of the log file.
show logging last number-lines
Displays the facility logging severity level
configuration.
show logging level [facility]
Displays the messages in the log file.
show logging logfile [start-time yyyy mmm dd
hh:mm:ss] [end-time yyyy mmm dd hh:mm:ss]
Displays the module logging configuration.show logging module
Displays the monitor logging configuration.show logging monitor
Displays the messages in the NVRAM log.
show logging nvram [last number-lines]
Displays the syslog server pending distribution
configuration.
show logging pending
Displays the syslog server pending distribution
configuration differences.
show logging pending-diff
Displays the syslog server configuration.show logging server
Displays the logging session status.show logging session
Displays the logging status.show logging status
Displays the logging time-stamp units configuration.show logging timestamp
Displays the running configuration for the ACL log
file.
show running-config acllog
Configuring ACL Logging
Information About ACL Logging
The Access Control List (ACL) logging feature allows the logging of the packets which hit the IPv4 ACLs.
The log message is displayed on a flow basis. The flow is identified using the combination of IP source address,
destination address, Layer 4 protocol, and the Layer 4 source/destination ports on an interface. The log message
is generated based on the following conditions:
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
108 OL-31641-01
Configuring System Message Logging
Configuring ACL Logging