Cisco Nexus 5600 Series - Verifying the ERSPAN Configuration

PurposeCommand or Action
Enables the ERSPAN session. By default, the session
is created in the shut state.
no shut
Example:
switch(config-erspan-src)# no shut
Step 7
(Optional)
Displays the status of ERSPAN sessions.
show monitor session all
Example:
switch(config-erspan-src)# show
monitor session all
Step 8
(Optional)
Displays the running ERSPAN configuration.
show running-config monitor
Example:
switch(config-erspan-src)# show
running-config monitor
Step 9
(Optional)
Displays the ERSPAN startup configuration.
show startup-config monitor
Example:
switch(config-erspan-src)# show
startup-config monitor
Step 10
(Optional)
Copies the running configuration to the startup
configuration.
copy running-config startup-config
Example:
switch(config-erspan-src)# copy
running-config startup-config
Step 11
Verifying the ERSPAN Configuration
Use the following command to verify the ERSPAN configuration information:
PurposeCommand
Displays the ERSPAN session configuration.
show monitor session {all | session-number | range
session-range}
Displays the running ERSPAN configuration.show running-config monitor
Displays the ERSPAN startup configuration.show startup-config monitor
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
214 OL-31641-01
Configuring ERSPAN
Verifying the ERSPAN Configuration