PurposeCommand or Action
Adds the show command output to any Call Home
messages sent for this alert group. Only valid show
commands are accepted.
switch(config-callhome)# alert-group
{Configuration | Diagnostic |
Environmental | Inventory | License |
Step 3
Linecard-Hardware |
You cannot add user-defined show
commands to the CiscoTAC-1 destination
profile.
Note
Supervisor-Hardware |
Syslog-group-port | System | Test}
user-def-cmd show-cmd
(Optional)
Displays information about all user-defined show
commands added to alert groups.
switch# show callhome user-def-cmds
Step 4
(Optional)
Saves the change persistently through reboots and
restarts by copying the running configuration to the
startup configuration.
switch(config)# copy running-config
startup-config
Step 5
The following example shows how to add the show ip routing command to the Cisco-TAC alert group:
switch# configuration terminal
switch(config)# callhome
switch(config-callhome)# alert-group Configuration user-def-cmd show ip routing
switch(config-callhome)#
What to Do Next
Configure Smart Call Home to connect to the SMTP e-mail server.
Configuring E-Mail Server Details
You must configure the SMTP server address for the Smart Call Home functionality to work. You can also
configure the from and reply-to e-mail addresses.
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Enters Smart Call Home configuration mode.switch(config)# callhome
Step 2
Configures the SMTP server as either the domain name
server (DNS) name, IPv4 address, or IPv6 address.
switch(config-callhome)# transport
email smtp-server ip-address [port
number] [use-vrf vrf-name]
Step 3
The number range is from1 to 65535. The default port
number is 25.
Optionally, you can configure the VRF instance to use
when communicating with this SMTP server.
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
OL-31641-01 131
Configuring Smart Call Home
Configuring E-Mail Server Details
To Next Page
Loading...
