Cisco Nexus 5600 Series - Configuring the NTP Source Interface; Configuring NTP Logging

Configuring the NTP Source Interface
You can configure NTP to use a specific interface.
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Configures the source interface for all NTP packets. The
following list contains the valid values for interface.
[no] ntp source-interface interface
Step 2
•
ethernet
•
loopback
•
mgmt
•
port-channel
•
vlan
This example shows how to configure the NTP source interface:
switch# configure terminal
switch(config)# ntp source-interface ethernet
Configuring NTP Logging
You can configure NTP logging in order to generate system logs with significant NTP events. NTP logging
is disabled by default.
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Enables or disables system logs to be generated with
significant NTP events. NTP logging is disabled by
default.
switch(config)# [no] ntp logging
Step 2
(Optional)
Displays the NTP logging configuration status.
switch(config)# show ntp
logging-status
Step 3
(Optional)
Saves the change persistently through reboots and
restarts by copying the running configuration to the
startup configuration.
switch(config)# copy running-config
startup-config
Step 4
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
228 OL-31641-01
Configuring NTP
Configuring the NTP Source Interface