Enabling CFS to Distribute FC Port Security Configurations
You can enable CFS to distribute Fibre Channel (FC) port security configurations in order to provide a single
point of configuration for the entire fabric in the VSAN and to enforce the port security policies throughout
the fabric.
Before You Begin
Make sure that you are in the storage VDC. To change to the storage VDC, use the switchto vdc fcoe command.
Make sure that you enable the FC port security feature. To do so, use the feature fc-port-security command.
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Enables CFS to distribute FC port security
configuration updates.
switch(config)# fc-port-security
distribute
Step 2
(Optional)
Displays the CFS distribution status.
switch(config)# show cfs application
Step 3
(Optional)
Saves the change persistently through reboots and
restarts by copying the running configuration to the
startup configuration.
switch(config)# copy running-config
startup config
Step 4
This example shows how to enable CFS to distribute FC port security configurations:
switch(config)# fc-port-security distribute
switch(config)# show cfs application
----------------------------------------------
Application Enabled Scope
----------------------------------------------
fc-port-securi Yes Logical
switch(config)# copy running-config startup-config
[########################################] 100%
Enabling CFS to Distribute FC Timer Configurations
You can enable CFS to distribute Fibre Channel (FC) timer configurations for all Cisco NX-OS devices in
the fabric.
Before You Begin
Make sure that you are in the storage VDC. To change to the storage VDC, use the switchto vdc fcoe command.
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
OL-31641-01 53
Using Cisco Fabric Services
Enabling CFS to Distribute FC Port Security Configurations
To Next Page
Loading...
