Cisco Nexus 5600 Series - Removing an Application from a Region; Deleting CFS Regions

PurposeCommand or Action
If you try moving an application to the same
region more than once, you see the "Application
already present in the same region" error
message.
Note
The following example shows how to move an application into Region 2 that was originally assigned to
Region 1:
switch# configure terminal
switch(config)# cfs region 2
switch(config-cfs-region)# ntp
Removing an Application from a Region
Removing an application from a region is the same as moving the application back to the default region
(Region 0), which brings the entire network into the scope of distribution for the application.
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Enters CFS region configuration submode.
switch(config)# cfs region region-id
Step 2
Removes application(s) that belong to the
region.
switch(config-cfs-region)# no application
Step 3
Deleting CFS Regions
Deleting a region nullifies the region definition. All the applications bound by the region are released back
to the default region.
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Deletes the region.
switch(config)# no cfs region region-id
Step 2
You see the, "All the applications in the
region will be moved to the default region"
warning.
Note
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
46 OL-31641-01
Using Cisco Fabric Services
Managing CFS Regions