Cisco Nexus 5600 Series - Committing the Active Package Set

PurposeCommand or Action
(Optional)
Displays all active packages. Use this command to
determine if the correct packages are active.
show install active
Example:
switch# show install active
Step 7
Committing the Active Package Set
When a SMU package is activated on the device, it becomes part of the current running configuration. To
make the package activation persistent across system-wide reloads, you must commit the package on the
device.
On startup, the device loads the committed package set. If the system is reloaded before the current active
package is committed, the previously committed package set is used.
Note
Before You Begin
Before you commit a package set, verify that the device is operating correctly and is forwarding packets as
expected. Complete the procedure described in Adding and Activating Packages.
Procedure
PurposeCommand or Action
Commits the current set of packages so that
these packages are used if the device is
restarted.
install commit filename
Example:
switch# install commit
n6000-uk9.7.2.1.N1.1.CSCuw28765.bin
Step 1
(Optional)
Displays which packages are committed.
show install committed
Example:
switch# show install committed
Step 2
This example shows how to commit active SMU packages on the device and then verify the committed
packages:
switch# install commit n6000-uk9.7.2.1.N1.1.CSCuw28765.bin
Install operation 2 completed successfully at Thu Jan 9 01:20:46 2014
switch# show install committed
Boot Images:
Kickstart Image: bootflash:/n6000-uk9-kickstart.7.2.1.N1.1.bin
System Image: bootflash:/n6000-uk9.7.2.1.N1.1.bin
Committed Packages:
n6000-uk9.7.2.1.N1.1.CSCuw28765.bin
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
OL-31641-01 343
Performing Software Maintenance Upgrades
How to Perform Software Maintenance Upgrades