Cisco Nexus 5600 Series - feature pim

•
BGPv6
•
Enhanced Interior Gateway Routing Protocol (EIGRP)
•
EIGRPv6
•
Intermediate System-to-Intermediate System (ISIS)
•
ISISv6
•
Open Shortest Path First (OSPF)
•
OSPFv3
•
RIP
Also supported are:
•
Virtual port channel (vPC) and vPC+
•
Interfaces
•
FabricPath
Starting with Cisco NX-OS Release 7.3(0)N1(1), the default mode for GIR is “isolate”. Use the system mode
maintenance command to put all the enabled protocols in maintenance mode. The switch will use the isolate
command to isolate the protocols from the network. The switch will then be isolated from the network but is
not shut down. Routing protocols will be running on the switch to maintain neighborship with peer switches
when it is isolated from the network. The isolate command is applied on the protocol instance and is applicable
for the following protocols:
•
Border Gateway Protocol (BGP)
•
BGPv6
•
Enhanced Interior Gateway Routing Protocol (EIGRP)
•
EIGRPv6
•
Intermediate System-to-Intermediate System (ISIS)
•
ISISv6
•
Open Shortest Path First (OSPF)
•
OSPFv3
•
FabricPath (Only applicable for Spine switches)
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
284 OL-31641-01
Configuring GIR (Cisco NX-OS Release 7.3(0)N1(1))
Information About GIR