Cisco Nexus 5600 Series - Feature History for GIR

OSPF (Maintenance mode)
Use the show ip ospf internal command to display OSPF status in maintenance mode:
switch# show ip ospf internal
ospf 100
ospf process tag 100
ospf process instance number 1
ospf process uuid 1090519321
ospf process linux pid 6968
ospf process state running (isolate)
System uptime 6d06h
SUP uptime 2 6d06h
Server up : L3VM|IFMGR|RPM|AM|CLIS|URIB|U6RIB|IP|IPv6|SNMP|MMODE
Server required : L3VM|IFMGR|RPM|AM|CLIS|URIB|IP|SNMP
Server registered: L3VM|IFMGR|RPM|AM|CLIS|URIB|IP|SNMP|MMODE
Server optional : MMODE
Early hello : OFF
Force write PSS: FALSE
OSPF mts pkt sap 324
OSPF mts base sap 320
Feature History for GIR
The table below summarizes the new and changed features for this document and shows the releases in which
each feature is supported. Your software release might not support all the features in this document. For the
latest caveats and feature information, see the Bug Search Tool at https://tools.cisco.com/bugsearch/ and the
release notes for your software release.
InformationReleaseFeature Name
The default mode for GIR is
“isolate”. Support for Unplanned
Maintenance, Maintenance Mode
timer, Supress FIB Pending,
Adding Show commands to
snapshots and dumping snapshot
sections.
7.3(0)N1(1)Graceful Insertion and Removal
(GIR)
This feature was introduced. The
default mode for GIR is
“shutdown”. Refer Configuring
GIR (Cisco NX-OS Release
7.1(0)N1(1)).
7.1(0)N1(1)Graceful Insertion and Removal
(GIR)
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
312 OL-31641-01
Configuring GIR (Cisco NX-OS Release 7.3(0)N1(1))
Feature History for GIR