EasyManua.ls Logo

Cisco Nexus 5600 Series - Page 333

Cisco Nexus 5600 Series
378 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
BGP AS path entries : 0
Bytes used by AS path entries : 0
Use the show bgp internal all statistics command to display the number of BGP IPv4 and IPv6 prefixes that
have been programmed and also the number of BGP IPv4 and IPv6 prefixes that have not been programmed:
BGP internal statistics information for VRF default, address family IPv4 Unicast
Total prefixes in BGP Table: 3
Total prefixes pending programming in HW: 0
BGP internal statistics information for VRF default, address family IPv6 Unicast
Total prefixes in BGP Table: 0
Total prefixes pending programming in HW: 0
EIGRP (Maintenance mode)
Use the show ip eigrp command to display EIGRP status in maintenance mode:
switch# show ip eigrp
IP-EIGRP AS 100 ID 30.1.1.1 VRF default
Process-tag: 100
Instance Number: 1
Status: running (isolate)
Authentication mode: none
Authentication key-chain: none
Metric weights: K1=1 K2=0 K3=1 K4=0 K5=0
IP proto: 88 Multicast group: 224.0.0.10
Int distance: 90 Ext distance: 170
Max paths: 8
Number of EIGRP interfaces: 1 (0 loopbacks)
Number of EIGRP passive interfaces: 0
Number of EIGRP peers: 1
Redistributing:
direct route-map passall
static route-map passall
Graceful-Restart: Enabled
Stub-Routing: Disabled
NSF converge time limit/expiries: 120/0
NSF route-hold time limit/expiries: 240/6
NSF signal time limit/expiries: 20/0
Redistributed max-prefix: Disabled
MMODE: Initialized
Suppress-FIB-Pending Configured
ISIS (Maintenance mode)
Use the show isis protocol command to display ISIS status in maintenance mode:
switch# show isis protocol
ISIS process : 100
Instance number : 1
UUID: 1090519320
Process ID 6969
VRF: default
System ID : 0300.0000.0004 IS-Type : L2
SAP : 412 Queue Handle : 16
Maximum LSP MTU: 1492
Stateful HA enabled
Graceful Restart enabled. State: Inactive
Last graceful restart status : none
Start-Mode Complete
BFD IPv4 is globally disabled for ISIS process: 100
BFD IPv6 is globally disabled for ISIS process: 100
Topology-mode is base
Metric-style : advertise(wide), accept(narrow, wide)
Area address(es) :
10
Process is up and running (isolate)
VRF ID: 1
Stale routes during non-graceful controlled restart
Interfaces supported by IS-IS :
Ethernet1/2
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
OL-31641-01 311
Configuring GIR (Cisco NX-OS Release 7.3(0)N1(1))
Verifying GIR at Protocol Level

Table of Contents

Other manuals for Cisco Nexus 5600 Series

Related product manuals