Cisco Nexus 5600 Series - Configuring CFS over IP; Enabling CFS over Ipv4; Enabling CFS over Ipv6

Configuring CFS over IP
Enabling CFS over IPv4
You can enable or disable CFS over IPv4.
CFS cannot distribute over both IPv4 and IPv6 from the same switch.Note
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Globally enables CFS over IPv4 for all
applications on the switch.
switch(config)# cfs ipv4 distribute
Step 2
(Optional)
Disables (default) CFS over IPv4 on the switch.
switch(config)# no cfs ipv4 distribute
Step 3
Enabling CFS over IPv6
You can enable or disable CFS over IPv6.
CFS cannot distribute over both IPv4 and IPv6 from the same switch.Note
Procedure
PurposeCommand or Action
Enters configuration mode.switch# configure
Step 1
Globally enables CFS over IPv6 for all
applications on the switch.
switch(config)# cfs ipv6 distribute
Step 2
(Optional)
Disables (default) CFS over IPv6 on the switch.
switch(config)# no cfs ipv6 distribute
Step 3
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
OL-31641-01 47
Using Cisco Fabric Services
Configuring CFS over IP