Cisco Nexus 5600 Series - Page 120

PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 2
Enables the switch to log messages to the console session
based on a specified severity level or higher (a lower number
switch(config)# logging console
[severity-level]
Step 3
value indicates a higher severity level). Severity levels range
from 0 to 7:
• 0 – emergency
• 1 – alert
• 2 – critical
• 3 – error
• 4 – warning
• 5 – notification
• 6 – informational
• 7 – debugging
If the severity level is not specified, the default of 2 is used.
(Optional)
Disables logging messages to the console.
switch(config)# no logging
console [severity-level]
Step 4
Enables the switch to log messages to the monitor based on
a specified severity level or higher (a lower number value
switch(config)# logging monitor
[severity-level]
Step 5
indicates a higher severity level). Severity levels range from
0 to 7:
• 0 – emergency
• 1 – alert
• 2 – critical
• 3 – error
• 4 – warning
• 5 – notification
• 6 – informational
• 7 – debugging
If the severity level is not specified, the default of 2 is used.
The configuration applies to Telnet and SSH sessions.
(Optional)
Disables logging messages to Telnet and SSH sessions.
switch(config)# no logging
monitor [severity-level]
Step 6
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
98 OL-31641-01
Configuring System Message Logging
Configuring System Message Logging to Terminal Sessions