Cisco Nexus 5600 Series - Page 291

PurposeCommand or Action
(Optional)
(Optional) Describes this flow exporter. You can
enter up to 63 alphanumeric characters for the
description.
description string
Example:
switch(config-flow-exporter)#
description exportversion9
Step 5
(Optional)
(Optional) Specifies the differentiated services
codepoint value. The range is from 0 to 63.
dscp value
Example:
switch(config-flow-exporter)# dscp 0
Step 6
(Optional)
(Optional) Specifies the UDP port to use to reach
the NetFlow collector. The range is from 0 to
65535.
If you do not specify the UDP port, 9995
is selected as the default.
Note
transport udp port
Example:
switch(config-flow-exporter)# transport
udp 200
Step 7
Specifies the NetFlow export version. Choose
version 9 to enter the flow exporter version 9
configuration submode.
version {5 | 9}
Example:
switch(config-flow-exporter)# version
9
Step 8
(Optional)
Sets the flow exporter statistics resend timer. The
range is from 1 to 86400 seconds.
option {exporter-stats | interface-table |
sampler-table} timeout seconds
Example:
switch(config-flow-exporter-version-9)#
option exporter-stats timeout 1200
Step 9
(Optional)
Sets the template data resend timer. The range is
from 1 to 86400 seconds.
template data timeout seconds
Example:
switch(config-flow-exporter-version-9)#
template data timeout 1200
Step 10
Returns to flow exporter configuration mode.exit
Example:
switch(config-flow-exporter-version-9)#
exit
Step 11
Returns to global configuration mode.exit
Example:
switch(config-flow-exporter)# exit
Step 12
(Optional)
Saves the change persistently through reboots
and restarts by copying the running configuration
to the startup configuration.
copy running-config startup-config
Example:
switch(config)# copy running-config
startup-config
Step 13
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
OL-31641-01 269
Configuring NetFlow
Creating a Flow Exporter