Cisco Nexus 5600 Series - Page 36

•
The committed switch profile is synchronized with the newly added peers (when they are online) if the
peer switch is also configured with configuration synchronization.
If you want to import a member interface to a switch profile, the port channel including the member
interface must also be present within the switch profile.
Before You Begin
After creating a switch profile on the local switch, you must add the second switch that will be included in
the synchronization.
Procedure
PurposeCommand or Action
Enters configuration synchronization mode.config sync
Example:
switch# config sync
switch(config-sync)#
Step 1
Configures switch profile, names the switch
profile, and enters switch profile
synchronization configuration mode.
switch-profile name
Example:
switch(config-sync)# switch-profile abc
switch(config-sync-sp)#
Step 2
Adds a switch to the switch profile.
sync-peers destination destination IP
Example:
switch(config-sync-sp)# sync-peers
destination 10.1.1.1
switch(config-sync-sp)#
Step 3
Exits switch profile configuration mode.exit
Example:
switch(config-sync-sp)# exit
switch#
Step 4
(Optional)
Displays the switch profile peer
configuration.
show switch-profile peer
Example:
switch# show switch-profile peer
Step 5
(Optional)
Copies the running configuration to the
startup configuration.
copy running-config startup-config
Example:
switch# copy running-config startup-config
Step 6
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
14 OL-31641-01
Configuring Switch Profiles
Adding a Switch to a Switch Profile