103
ENGINE
AUXILIARY EQUIPMENT DRIVE BELT
Engines: RHM - RHT - RHW
Removing (continued).
Slacken the fixing (2).
Action the roller (3), using tool [1], until the tool [2] is positioned in the pegging hole (A).
Bring the roller (3) back towards the rear.
Gently tighten the screw (2).
Remove the belt.
ESSENTIAL : Check that the rollers (3) and (4) turn freely (no play, no tight spot).
Refitting.
IMPERATIVE: If re-using the belt, refit it respecting the direction of rotation marked on removal.
Refit the belt, finishing with the tensioner roller (4).
Action the roller (3), using tool [1] (clockwise) to free the tool [2].
Tighten the fixing (2) to 4,5 ± 0,5 m.daN, without altering the position of the roller.
ESSENTIAL: Check that the belt is correctly positioned in the grooves of the various pulleys.
Remove the tool [1].
Rotate the engine four times
.
Check that the marks (B) and (C) coincide.
Tool [3] should be able to engage freely, if not, repeat the adjustment.
Complete the refitting.
B1BK1A4C
C8
Angl.T3-page032-190-2005 4/02/05 15:15 Page 103
To Next Page
Loading...
