CITROEN C5 2005 - Setting at Reference Height; Requirements Prior to Setting at Reference Height; Tooling Required

272
AXLES
SUSPENSION
STEERING
AXLE GEOMETRY
Setting at reference height
Requirements prior to setting at reference height
WARNING: The checks of the front and rear axle geometry values, as well as the adjusting of the front suspension should be carried out
at precise positions of suspension compression (reference height) on a suspension test bed.
Check the pressures in the tyres.
Check the conformity of the tyres.
Remove the wheel trims.
Lock the steering rack at point zero: straight ahead (see corresponding operation).
Tooling required.
[1] Set of two compressors : 9511-T.A
[2] Set of two shackles : 9511-T.C
[3] Set of four straps : 9511-T.B
[4] Set of two slings : 9511-T.D
[5] Under body height gauge : 2305-T
C8
Angl. T3-page256-281-2005 4/02/05 15:25 Page 272