315
HYDRAULICS
B4BP01MC
DRAINING - FILLING - BLEEDING: HYDRAULIC SUSPENSION/STEERING CIRCUIT
Filling.
Couple the hose (2).
Refit:
- A new clip (1).
- The front RH splash-shield.
- The front RH wheel.
Lower the vehicle.
Open the cap (3).
Add LDS fluid to bring the level between the minimum mark "b" and the maximum mark "a".
Bleeding.
Apply a pressure of 0,5 bars in the LDS fluid reservoir (using tool: FACOM 920).
Start the engine.
Wait for the vehicle height to stabilise.
Place the suspension height control in the "HIGH" position.
Place the suspension height control in the "LOW" position.
Move the steering in both directions, from lock to lock.
Stop the engine.
Check that the LDS fluid level is between the minimum mark "b" and the maximum mark "a".
C5
Angl.T3-page300-321-2005 4/02/05 15:33 Page 315
To Next Page
Loading...
