CITROEN C5 2005 - Front;Rear Brake Caliper; Using the Bleeding Apparatus

291
BRAKES
B3FP13CC
DRAINING, FILLING AND BLEEDING THE BRAKING SYSTEM
Front brake caliper : Bleed screw (5).
Rear brake caliper : Bleed screw (6).
Bleed each wheel cylinder, proceeding in the following order:
- Front LH wheel.
- Front RH wheel..
- Rear LH wheel.
- Rear RH wheel
Using the bleeding apparatus.
Connect the bleeding apparatus [1] on the brake fluid reservoir (1).
Adjust the apparatus pressure to 2 bars.
For each brake circuit:
- Connect a transparent tube onto the bleed screw.
- Submerge the other end of the tube in a clean container.
- Open the bleed screw
- Wait until the fluid is flowing out without air bubbles.
- Close the bleed screw.
- Remove the bleeding apparatus.
- Check the brake fluid level (should be between «DANGER» level and
«MAXI» level).
- Fill if necessary with the approved and recommended synthetic brake fluid.
C5
B3FP13BC
B3FP13DC
Angl.T3-page282-299-2005 4/02/05 15:29 Page 291