53
ENGINE
SPECIAL FEATURES: TIGHTENING TORQUES (m.daN)
Engine: XFW
Cooling circuitLubrication circuit
Coolant pumpOil pump
Stage 1: Position the screws and do them up by hand.
Stage 2: Pre-tighten the screws : 0,5.
Stage 3: Tighten the screws : 0,8.
Stage 4: Repeat the tightening a few times in the same order to obtain
a tightening torque of 0,8 m.daN on all the screws.
Stage 1: Position the screws and do them up by hand.
Stage 2: Pre-tighten the screws : 0,5.
Stage 3: Tighten the screws : 0,8.
Stage 4: Repeat the tightening a few times in the same order to obtain a
tightening torque of 0,8 m.daN on all the screws.
B1BK3B6D B1BK3B7D
Respect the sequence of stages and the order of tightening
C8
Angl.T3-page032-190-2005 4/02/05 15:15 Page 53
To Next Page
Loading...
