246
CLUTCH
GEARBOX
TRANSMISSION
4 HP 20 “SHIFT LOCK” GEARBOX CONTROL SPECIFICATIONS AND PRECAUTIONS
Engine: 4HX
SHIFT LOCK.
The “shift lock” is a system which locks the gear selection lever in the park position «P».
Unlocking the “shift lock” (normal operation).
Switch on the ignition.
Apply the brake pedal and keep it pressed.
Using the selection lever, disengage from position «P».
Unlocking the “shift lock” (with a fault).
If it should be impossible to unlock the shift lock with the normal operation method, the causes of the fault
may arise from the following components:
- “Shift lock”.
- Gear lever position switch.
- Automatic gearbox ECU.
- Electrical harnesses.
- Battery voltage.
Remove:
- The gear lever knob (1) by pulling upwards.
- The cover (2) (unclip).
- The shutter.
Unlock the “shift lock” (4) using a screwdriver.
Move the selection lever to disengage from position «P».
C5FP0CUD
C5FP0CTC
C5
Angl.T3-page207-255-2005. 4/02/05 15:19 Page 246