BRAKES
289
B3FP7DDD
CHECKING AND ADJUSTING THE PARKING BRAKE
(3) Nut for adjusting the tension of the parking brake cables
Apply and release the parking brake lever 5 times.
Place the parking brake lever in the released position.
Tighten the nut (3) until it is in contact with the component (4).
Apply and release the parking brake lever 5 times.
Place the parking brake lever in the released position.
Check:
- That there is no clearance between the extremities of the parking brake cables and
the slide.
- That the RH and LH caliper levers (2) are against the screws (1).
IMPERATIVE: If these two checks are not satisfactory, repeat the adjustment
procedure.
Lower the vehicle.
Refit the central console.
C5
Angl.T3-page282-299-2005 4/02/05 15:29 Page 289