320
HYDRAULICS
B3BP165C
DRAINING - FILLING - BLEEDING: HYDRAULIC SUSPENSION/STEERING CIRCUIT
Adjusting of heights using diagnostic tool [2] or [3].
Connect diagnostic tool [2] or [3] to the vehicle diagnostic socket.
Go into the menu:
- Adjustment of reference heights.
- Configuration.
NOTE: H1M = front measured height (mm).
Except CARLSSON : Calculate 280 - (R1-H1M) for the front.
CARLSSON : Calculate (R1-H1M) for the front.
Re-enter this value in the diagnostic tool.
NOTE: H2M = rear measured height (mm).
Calculate (H2M-R2) for the rear.
Re-enter this value in the diagnostic tool.
Wait for the correction of the vehicle height.
Measure the front height (H1M).
Check that: H1C ± 2 mm.
Measure the rear height (H2M).
Check that: H2M = H2C ± 2 mm.
C5
B3BP164C
Angl.T3-page300-321-2005 4/02/05 15:33 Page 320
To Next Page
Loading...
