186
ENGINE
CHECKING AND SETTING THE VALVE TIMING
Engines: RHM - RHT - RHW - 4HW
B1EK1T0D
Checking the timing setting.
Effect two turns of the engine in the normal direction of rotation, without turning the engi-
ne backwards.
Refit the peg [2].
IMPERATIVE: Check visually that the offset between the hole in the camshaft hubs
and the corresponding pegging hole is not more than 1 mm.
Remove the peg [2].
Refit:
- The lower timing cover.
- The elements (3) of the timing cover.
- The engine support (4).
- The screws (13), tighten to 6,1 ± 0,6 m.daN.
- The nut (12), tighten to 4,5 ± 0,4 m.daN.
IMPERATIVE: Apply an opposite torque at (A).
Refit:
- The torque reaction rod (1).
- Screw (14), tighten to 5 ± 0,5 m.daN.
- Screw (15), tighten to 5 ± 0,5 m.daN.
C8
Angl.T3-page032-190-2005 4/02/05 15:15 Page 186
To Next Page
Loading...
