197
INJECTION
B1BP28EC
C5FPOBLC
CHECKS: TURBO PRESSURE
Engine: 4HX
Preparation of tools: In position on the vehicle (continued).
Screw the tool [3] on the take-off of the turbo air radiator at «c».
Place the pressure gauge on the cup holder at «d».
Connect the extension [2] on the hose «b» and tool [5].
ESSENTIAL: Observe the following checking requirements.
Start the engine.
Engage first gear and start the vehicle.
Engage the gears up to third gear.
Decelerate to 1500 rpm.
Accelerate gradually: the pressures should be the following:
- 1.1 ± 0.05 b at 2000 rpm
- 1.2 ± 0.05 b at 3000 rpm.
Return the vehicle to normal.
Remove the tools [1], [2], [3], [4] and [5].
Reposition the pressure sensor (3).
Couple the tube (2).
Refit and tighten the screw (1).
C5
Angl.T3-page191-206-2005 4/02/05 15:05 Page 197
To Next Page
Loading...
