Name: Clarke Clean Track® L24 56317170
Brand: Clarke
Rating: 4 (1 reviews)

Service Manual1

Table of Contents2

Introduction6

General Maintenance10

Batteries57
- If Your Machine Shipped with Batteries Installed, Do the Following57
- If Your Machine Shipped Without Batteries Installed Do the Following57
- When Servicing Batteries57
Specific Wet Cell Battery Information58
- Wet Cell Battery Specifications58
- Wet Cell Battery Charger Specifications58
Description of the Low-Voltage Cutout Feature59
Description of the Battery Condition Indicators59
Explanation of Battery Indicator Lights and Voltage Ranges59
Charging Wet Batteries60
When Servicing Wet Batteries60
- If Your Machine Shipped with an Onboard Battery Charger, Do the Following60
- If Your Machine Shipped Without an Onboard Battery Charger, Do the Following60
Checking the Battery Water Level60
Charging Gel (VRLA) Batteries61
When Servicing Gel (VRLA) Batteries61
- If Your Machine Shipped with an Onboard Battery Charger, Do the Following61
- If Your Machine Shipped Without an Onboard Battery Charger, Do the Following62
Wet Cell Battery Maintenance62
Battery Testing62
Actuator Drive Nut Adjustment63
- General Instructions63
- Adjusting the Drive Nut on the Scrub Brush Lift Actuator64
Curtis Controller Diagnostics66
- Diagnostics Method a - LED Panel and Speed Control Fault Code Indicator66
- Diagnostics Method B - Curtis Programmer66
- Diagnostic History67
Speed Control Programming Options69
Installation Checkout for the Curtis Speed Controller69
Programming Vehicle Speed Changes70
Maintenance70
Functional Overview of the Main Control Board70
Troubleshooting Guide71
Main Controller Error Codes71
Service Test Mode73
- To Enter the Service Test Mode73
- Panel Indicators - Service Test Mode73
- To Run the Wheel Drive Motor74
- To Switch the Solution System on and off74
- To Lower and Raise the Scrub Deck74
- To Switch the Vacuum Motors on and off75
- To Extend and Retract the Vacuum Shoe Pin75
- To Switch the Scrub Brush Motors on and off75
- To Switch the On-Board Chemical Mixing System on and off76
Main Control Programming Options76
- Selecting the Low Voltage Cutout Threshold76
- Selecting the Scrub Pressure Current Limits76
- Restoring the Scrub Pressure Limits to the Factory Default Settings78
- Recall of Stored Error Codes78
- Turning Fault Detection on or off78
- Displaying the Control Unit Revision Level79
- Enabling/Disabling the Chemical Mixing System79
- Detergent Dilution Ratio Selection80
- Factory Reset80

Electrical Wiring Diagram/Schematic82

Electrical Ladder Diagram83

Detergent (Chemical Mixing) System Plumbing Schematic84

Detergent (Chemical Mixing) System Preparation and Use85

Brand	Clarke
Model	Clean Track® L24 56317170
Category	Floor Machine
Language	English

Clarke Clean Track® L24 56317170 User Manual

Table of Contents

Questions and Answers:

Clarke Clean Track® L24 56317170 Specifications

Related product manuals