6. To lower the Lid Assembly,
loosen off the screws in the
Hinge Brackets, at both ends,
while holding the Lid
Assembly, until the lid can
move freely.
7. Lower the Lid Assembly to
the correct position to
reattach the 3 x M4 screws of
the Right Gas Piston. Make
sure not to drop the screws
into the scanner.
8. Similarly, reattach the Left
Gas Piston with the 3 x M4
screws. Make sure not to
drop the screws into the
scanner.
9. Close the Lid Assembly.
To Next Page
Loading...
