18. To refit the Lid Assembly,
lower one end into place;
making sure the cable from
the Inner Hinge Bracket goes
through the appropriate hole
in the End Plate.
19. Lower the other end down
and feed the cable through
the appropriate hole in the
End Plate before allowing the
Lid Assembly lower
completely.
NOTE: Both Inner Hinge Brackets have nylon
washers fitted to centralise the Lid Assembly,
make sure these are still in place before
lowering the Lid Assembly.
20. Refit the Outer Hinge
Brackets at either end of the
Lid Assembly using the 3 x
M5 screws, but do not
tighten.
To Next Page
Loading...
