Colortrac M25e - Page 64

M Series Service Manual
Page 64 of 129
3. Remove the Control Board
Bracket as described in
chapter “14.2 Control Board”
page 53.
4. Gently lift the locking bar on
the ribbon cable connector,
make sure not to use
extreme force which could
break the connector.
5. Gently pull the ribbon cables
from the 3 (M40) or 2 (M25) x
connectors.
6. Fix the Lid Assembly into the
maintenance position as
described in chapter “13.1
Lid Assembly Maintenance
Position” on page 17.