14. Line up the flat of the Drive
Roller Unit Shaft and the
Drive Pulley keyway and
push completely on.
15. Using pliers, refit the E Clip
onto the Drive Roller Unit
Shaft to hold the Pulley in
place.
16. Refit the Main Timing Belt as
described in chapter “14.8
Main Timing Belt” page 84.
NOTE: When fitting the Rear Drive Roller Unit,
also refit the Drive Roller Timing Belt as
described in chapter “14.9 Drive Roller Timing
Belt” page 88.
17. Refit the appropriate Lower
Covers as described in
chapter “13.6 Lower Covers”
page 31.
NOTE: For the Rear Drive Roller Unit, refit the
Lid Assembly as described in chaper “13.8 Lid
Assembly” page 37”.
To Next Page
Loading...
