. . . . . . . . . . . . . . . . . . . . . . . . .
Appendix D
Power Cord Set Requirements
D-1
Part Number: 262446-001 Writer: Dianne Fielden Saved by: JohnnieA
Saved Date: 02/26/96 1:22 PM 12:18 PM File Name: APPD.DOC
Power Cord Set
Requirements
The wide-range input feature of your AC Adapter permits it to
operate from any line voltage between 100 to 240 volts AC.
The power plug or power cord set (appliance coupler, flexible cord,
and wall plug) you received with your AC Adapter meets the
requirements for use in the country where you purchased your
computer.
Power cord sets for use in other countries must meet the
requirements of the country where you use the AC Adapter. For
more information on power cord set requirements, contact your
Compaq authorized dealer.
General Requirements
The requirements listed below are applicable to all countries:
1. The length of the power cord set must be at least 6.00 feet (1.8
m) and a maximum of 9.75 feet (3.0 m).
2. All power cord sets must be approved by an acceptable
accredited agency responsible for evaluation in the country
where the power cord set will be used.
3. The power cord set must have a minimum current capacity of
2.5A and a nominal voltage rating of 125 or 250 volts AC, as
required by each country’s power system.
4. The appliance coupler must meet the mechanical configuration
of an EN 60 320/IEC 320 Standard Sheet C7 connector, for
mating with appliance inlet on the AC Adapter.
To Next Page
Loading...
Need help?
General