. . . . . . . . . . . . . . . . . . . . . . . . .
Diagnostics
10-3
Part Number: 262446-001 Writer: Dianne Fielden Saved by: JohnnieA
Saved Date: 02/26/96 10:45 AM 12:20 PM File Name: CH10.DOC
8. Verify that Computer Checkup correctly detected the devices
installed.
NOTE
:
Devices from other manufacturers may not be detected or
may be reported inaccurately.
■
If the list is correct, select OK. The test option menu is
displayed again. Go to step 9.
■
If the list is incorrect, ensure that any new devices are
installed properly. If you do not find an installation problem,
call your Compaq authorized service provider.
9. Select one of the following from the test option menu:
■
Quick Check Diagnostics
—Runs a quick, general test on each
device with a minimal number of prompts. If errors occur,
they are displayed when the testing is complete.
■
Automatic Diagnostics
—Runs unattended, maximum testing
of each device with minimal prompts. You can choose how
many times to run the tests, to stop on errors, or to print or
file a log of errors.
■
Prompted Diagnostics
—Allows maximum control over the
device testing process. You can choose attended or
unattended testing, decide to stop on errors, or choose to print
or file a log of errors.
10. Follow the instructions on the screen as the devices are tested.
When the testing is complete, the test option menu is displayed
again.
NOTE
: When you run Computer Checkup, record any error
message numbers and have them available when you contact
your Compaq authorized reseller or service provider for
assistance.
11. Exit to the Configuration and Diagnostics menu.
To Next Page
Loading...
Need help?
General