EasyManuals Logo

Compaq Portable II User Manual

Compaq Portable II
118 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
drive and retest.
614 - 02 Exceeded maximum hard error limit 6. Replace the system
board and retest.
614 - 03 Previously exceeded maximum soft error
limit
614 - 04 Previously exceeded maximum hard error
limit
------------------------------------------------------------------------------
Error
Codes Error Description Recommended Action
------------------------------------------------------------------------------
614 - 05 Failed to reset controller The following steps apply to
error codes 600 - xx through
614 - 06 Fatal error while reading 614 - xx:
614 - 07 Fatal error while writing NOTE: If the COMPAQ
Enhanced Color Graphics
614 - 08 Failed compare of write/read buffers Board is installed, check
the interrupt setting.
614 - 09 Failed to format a track
1. Replace the diskette and
614 - 10 Failed sector wrap test retest.
2. Check the switch and
614 - 20 Failed to get drive type jumper settings on the
multipurpose fixed disk
614 - 21 Failed to get change line status drive controller board
or the multipurpose
614 - 22 Failed to clear change line status controller board.
3. Replace the diskette
614 - 23 Failed to set drive type in ID media power and signal cables
and retest.
614 - 24 Failed to read diskette media 4. Replace the multipurpose
fixed disk drive
614 - 25 Failed to verify diskette media controller board or
multipurpose controller
614 - 26 Failed to read media in speed test board and retest.
5. Replace the diskette
614 - 27 Failed speed limits drive and retest.
6. Replace the system
614 - 28 Failed write protect test board and retest.
614 - 29 Failed to read media in file write
test
614 - 40 Cylinder 0 error
------------------------------------------------------------------------------
Error
Codes Error Description Recommended Action
------------------------------------------------------------------------------
694 - 00 Pin 34 is not cut on 360 KB diskette See Service Bulletin 25,
drive Modification of 360 Kbyte
Diskette Drives.
697 - 00 Diskette type error
1. Replace the diskette
698 - 00 Diskette drive speed not within and retest.
limits 2. Check the switch and
jumper settings on the
multipurpose fixed disk
drive controller board

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Compaq Portable II and is the answer not in the manual?

Compaq Portable II Specifications

General IconGeneral
BrandCompaq
ModelPortable II
CategoryDesktop
LanguageEnglish

Related product manuals