Compaq Portable II User Manual

or the multipurpose
controller board.
3. Replace the diskette
power and signal cables
and retest.
4. Replace the
multipurpose fixed disk
drive controller board
or multipurpose
controller board and
retest.
5. Replace the diskette
drive and retest
6. Replace the system
board and retest.
------------------------------------------------------------------------------
699 - 00 Diskette drive/media ID error Rerun the SETUP program.
==============================================================================
Table 5-8. Serial Interface Test Error Codes
==============================================================================
Error
Codes Error Description Recommended Action
------------------------------------------------------------------------------
1101 - 01 Serial port test, UART DLAB bit The following steps apply
failure to error codes 101 - 01
through 1101 - 14;
1101 - 02 Serial port test, line input or UART
fault 1. Check jumper and switch
settings on the
1101 - 03 Serial port test, address line fault serial/parallel
interface board,
1101 - 04 Serial port test, data line fault multipurpose fixed disk
drive controller board,
1101 - 05 Serial port test, UART control signal or the multipurpose
failure controller board and
retest.
1101 - 06 Serial port test, UART THRE bit 2. Replace the
failure serial/parallel
interface board,
1101 - 07 Serial port test, UART DATA READY multipurpose fixed disk
bit failure drive controller board
or multipurpose
1101 - 08 Serial port test, UART TX/RX buffer controller board and
failure retest.
1101 - 09 Serial port test, INTERRUPT circuit
failure
1101 - 10 Serial port test, COM1 set to invalid
interrupt
1101 - 11 Serial port test, COM2 set to invalid
interrupt
1101 - 12 Serial port test, DRIVER/RECEIVER
control signal failure
1101 - 13 Serial port test, UART control signal
interrupt failure

Compaq Portable II Specifications

General

Brand	Compaq
Model	Portable II
Category	Desktop
Language	English