17yy - 4l Drive not ready
17yy - 42 Recalibration failed
------------------------------------------------------------------------------
Error
Codes Error Description Recommended Action
------------------------------------------------------------------------------
17yy - 43 Failed to format bad track The following steps apply
to error codes 1700 - xx
17yy - 44 Failed fixed disk drive controller through 1716 - xx:
board diagnostics
1. Check switch and jumper
17yy - 45 Failed to get drive parameters from settings on the fixed
ROM disk drive controller
board, multipurpose
17yy - 46 Invalid drive parameters found in ROM fixed disk drive
controller board, or
17yy - 47 Failed to park heads multipurpose controller
board and retest.
17yy - 48 Failed to move disk table to RAM 2. Replace the fixed disk
drive signal and power
17yy - 49 Failed to read media in file write cables and retest.
test 3. Replace the fixed disk
drive controller
17yy - 50 Failed file I/O write test board, multipurpose
fixed disk drive
17yy - 5l Failed file I/O read test controller board, or
multipurpose controller
17yy - 52 Failed file I/O compare test board and retest.
4. Replace the fixed disk
drive and retest.
5. Replace the system
board and retest.
17yy - 53 Failed drive/head register test
17yy - 54 Failed digital input register test
------------------------------------------------------------------------------
Error
Codes Error Description Recommended Action
------------------------------------------------------------------------------
17yy - 55 Failed cylinder 1 test The following steps apply
to error codes 1700 - xx
17yy - 56 Fixed disk drive controller board through 1716 - xx:
RAM diagnostics failed
1. Check switch and jumper
17yy - 57 Fixed disk drive controller board settings on the fixed
to drive test failed disk drive controller
board, multipurpose
17yy - 58 Failed to write sector buffer fixed disk drive
controller board, or
17yy - 59 Failed to read sector buffer multipurpose controller
board and retest.
17yy - 60 Failed to compare sector buffer 2. Replace the fixed disk
drive signal and power