17yy - 63 Failed soft error rate cables and retest.
3. Replace the fixed disk
17yy - 65 Exceeded maximum bad sector per track drive controller
board, multipurpose
17yy - 66 Failed initial drive parameter fixed disk drive
controller board, or
17yy - 67 Failed to write long multipurpose controller
board and retest.
17yy - 68 Failed to read long 4. Replace the fixed disk
drive and retest.
17yy - 69 Failed to read drive size from 5. Replace the system
controller board and retest.
17yy - 70 Failed translate mode
17yy - 71 Failed nontranslated mode
17yy - 72 Bad track limit exceeded
17yy - 73 Previously exceeded bad track limit
==============================================================================
Table 5-11. Enhanced Color Graphics Test Error Codes
==============================================================================
Error
Codes Error Description Recommended Action
-----------------------------------------------------------------------------
2402 - 01 Video memory test failed The following steps apply
to error codes 2402 - 01
2403 - 01 Video attribute test failed through 2416 - 01:
2404 - 01 Video character set test failed 1. Verify the switch
settings.
2405 - 01 Video 80 x 25 mode9x14character 2. Replace the COMPAQ
cell test failed Enhanced Color Graphics
Board ROM and retest.
2406 - 01 Video 80 x 25 mode8x8character 3. Replace the COMPAQ
cell test failed Enhanced Color Graphics
Board and retest.
2407 - 01 Video 40 x 25 mode test failed 4. Replace the system
board and retest.
2408 - 01 Video 320 x 200 mode color set 0 test
failed
2409 - 01 Video 320 x 200 mode color set 1 test
failed
2410 - 01 Video 640 x 200 mode test failed
2411 - 01 Video screen memory page test failed
2412 - 01 Video gray scale test failed
2414 - 01 Video white screen test failed
2416 - 01 Video noise pattern test failed
To Next Page
Loading...
Need help?
General