104
Compulite
Chapter 5
To release fixtures from a temporary cue
Example: Release the fixtures in the editor from the temporary cue on
fader 6.
1. Select fixtures.
2. Press
STORE.
3. Press
SELECT for fader 6.
The
Object Exists dialog box opens.
4. Ta p
RELEASE.
5. The fixtures are removed from the temporary cue.
To convert a temporary cue to a cue in a new QList
Scenario: The show already contains QLists 1- 3. Covert the temporary
cue, on fader 10 to cue 1 in a new QList (Qlist 4) and store the active
editor content as cue 2 in the same QList.
First, assign a temporary cue:
1. Select fixtures and assign values.
2. Press
STORE.
3. Press
SELECT for fader 10.
Now, create a new lighting state:
1. Select fixtures and assign values.
2. Press
STORE.
3. Press
SELECT for fader 10. The Object Exists dialog box opens.
4. Choose Create
New QList. The dialog box closes. The command line
shows:
QList 4 Cue 2 Assigned. QList 4 now has two cues; the original
temporary cue (group) is now cue 1.
To Next Page
Loading...