77
VECTOR
PROGRAMMING AND UPDATING CUES
Multiple QLists
While programming a show, you may have a number of Qlists loaded to
different playback devices. Storing cues to the different QLists is done
as described in Storing QLists and cues
(see page 69).
Note: The QList located on the master playback device is the default
QList. This means that unless you specify a Qlist when storing a cue,
the new cue is stored to the default QList. See:“
Master Playback” on
page 94.
To store a cue to any playback device
Example: Store cue 1 in QList 11. QList 11 is resident in fader 6.
1. Select fixtures and assign values.
2. Press
STORE.
3. Press
SELECT for fader 6.
The command line shows:
Playback 1/6: QList 11 Cue 1 Stored.
OR
1. Select fixtures and assign values.
2. Press
QLIST 11.
3. Press
CUE 1.
4. Press
STORE.
The command line shows:
Playback 1/6: QList 11 Cue 1 Stored.
To add cues to the QList on any playback device
Example 1: Store cue 2 (the next available cue number) in QList 11,
loaded on fader 6. The next cue number is the current cue incremented
by one.
1. Select fixtures and assign values.
2. Press
STORE
3. Press
SELECT for fader 6.
The command line shows:
Playback 1/6: QList 11 Cue 2 Stored.
To Next Page
Loading...
Need help?
General
