112
Compulite
Chapter 6
4. Use the appropriate parameter wheel to fan the selection. Vector
sets the offset according to the selected fan type and the fixture
selection order.
5. Store as a cue.
To choose the fan type and set the fan spread
1. Select a range of fixtures.
2. Optional - Select a parameter.
If no parameter is selected, the fan defaults to the dimmer
parameter.
3. Press
@ and enter a parameter value range. Example: SPOT 1 6 @
25 85.
The
Editor tool bar switches to fan mode. Fan right is the default
selection.
4. Press
ENTER.
5. Optional - change the fan type.
6. Optional - adjust the value offset using the appropriate parameter
wheel
7. Store as a cue.
Fan timing
Use fan timing to create a quick and simple effect.
Tip! To view fan time, set display format to settings: Format menu > Time.
To set fan timing
1. Select fixtures.
2. Select a parameter and assign values.
3. Press
TIME.
The tool bar is in time mode.
Continued on next page...
To Next Page
Loading...