33
VECTOR
STARTING A NEW SHOW AND PATCHING
3. Enter the fixtures’ numbers in the From No. and To N o . fields.
4. Ta p
OK to update and close the dialog box. The selected fixtures are
deleted from the patch and no longer appear in the grid.
Or
Tap
APPLY and keep the dialog box open.
To clear addresses
1. Select the appropriate Set.
2. Ta p . Th e
Clear Patch dialog box opens.
3. Enter the fixtures’ desk numbers in the
From No. and To No. fields.
4. Ta p
OK to update and close the dialog box. The patch for the
selected fixtures is cleared and no longer appears in the grid.
Or
Tap
APPLY and keep the dialog box open.
To adjust pan and tilt orientation in the patch manager
1. Select the spot set.
2. Ta p .
Or
Right click on the fixture cell and choose
Modify Range from the
shortcut menu.
The
Modify Fixtures wizard opens.
3. Enter the range of fixtures in the
Fixture no. field.
4. Ta p
NEXT.
5. Choose all or one of the following options:
INVERT PAN
INVERT TILT
SWAP PAN/TILT
6. Ta p FINISH.
Tip! You can also set the Pan/Tilt patch via the Editor toolbar outside
the Patch manager.
To Next Page
Loading...
Need help?
General
