43
VECTOR
SELECTING AND CONTROLLING FIXTURES
— (minus) Used to remove a channel/spot form a range selection.
Example:
SPOT 1 5 — 4, selects channels 1, 2, 3, 5.
(dot)
or wheel
Makes the last selection available. Example: Before
pressing
RESET, the selection was spots 1, 3, 6, and 8.
Press
SPOT or move a parameter wheel to access the last
fixture selection.
Fixture
Note: This is not a key on the console panel.
When fixture numbers in the various sets do not overlap,
the command line numeric default is automatically set to
Fixture. When using this setup, it is not necessary to select a
set prior to selecting the fixture numbers.
Example:
Channels are numbered 1 100.
Spots are numbered 101 164.
To select (channel) 98, press 98 on the keypad; press 124
to select spot 124.
Key Name What it does
To Next Page
Loading...
Need help?
General
