Comtech EF Data UT-4500 Series - Page 10

UT-4500 Series C- and Ku-Band Up Converters MN/UT4500.IOM / CD/UT4500.IOM
Table of Contents Revision 3
viii
5.4 Upload the Firmware Files and Update the UT-4500 Unit ................. 5–11
5.4.1 Important Considerations .................................................................. 5–11
5.4.2 Steps to “CReflash” Upload the Firmware Files ................................. 5–12
5.4.3 Steps to FTP Upload the Firmware Files ............................................ 5–13
5.4.4 Steps to Complete the Firmware Update Procedure ......................... 5–13
5.4.4.1 Select the Boot Image ................................................................ 5–14
5.4.4.1.1 Use the Front Panel to Select the Boot Image ..................... 5–14
5.4.4.1.2 Use the HTTP Interface to Select the Boot Image ................ 5–14
5.4.4.2 Reboot the Unit .......................................................................... 5–14
5.4.4.2.1 Hard-reboot the Unit from the Rear Panel .......................... 5–14
5.4.4.2.2 Soft-Reboot the Unit from the HTTP Interface .................... 5–15
CHAPTER 6. FRONT PANEL OPERATION ........................................ 6–1
6.1 Front Panel Overview ........................................................................ 6–1
6.1.1 Power Up the Unit ............................................................................... 6–2
6.1.2 LED Indicators ....................................................................................... 6–3
6.1.3 Vacuum Fluorescent Display (VFD) ...................................................... 6–4
6.1.4 Keypad .................................................................................................. 6–5
6.2 Front Panel Operation – Menu Matrix ............................................... 6–6
6.2.1 Opening Screen .................................................................................... 6–7
6.2.2 Main Menu ........................................................................................... 6–7
6.2.3 (SELECT:) CONFIG (Configuration) Menu Branch ................................. 6–8
6.2.3.1 (CONFIG:) OUTPUT Submenu ....................................................... 6–8
6.2.3.1.1 (CONFIG:) OUTPUT Submenu (OPTIONAL DUAL IF RACK
MOUNT CONVERTERS) ............................................................................. 6–9
6.2.3.2 (CONFIG:) REMOTE (Remote Control) Submenu ........................ 6–10
6.2.3.2.1 (REMOTE:) Local ................................................................... 6–10
6.2.3.2.2 (REMOTE:) SERIAL ................................................................ 6–10
6.2.3.2.3 (REMOTE:) ETHERNET .......................................................... 6–11
6.2.3.2.3.1 (REMOTE:) ETHERNETADDRESS ................................. 6–11
6.2.3.2.3.2 (REMOTE:) ETHERNETGATEWAY ................................ 6–11
6.2.3.2.3.3 (REMOTE:) ETHERNETSNMP ...................................... 6–12
6.2.3.3 (CONFIG:) REDUNDANCY Submenu ........................................... 6–14
6.2.3.3.1 (REDUNDANCY:) MODE ........................................................ 6–14
6.2.3.3.2 (REDUNDANCY:) Auto/Manual ............................................. 6–15
6.2.3.3.3 (REDUNDANCY:) FORCE ........................................................ 6–15
6.2.3.3.4 (REDUNDANCY:) HSB ............................................................ 6–16