UT-4500 Series C- and Ku-Band Up Converters MN/UT4500.IOM
Firmware Update Revision 3
5–12
5.4.2 Steps to “CReflash” Upload the Firmware Files
1) The “CReflash” utility is provided with the firmware download.
2) Ver5x chassis and earlier units (i.e., non-Ethernet units) must use this
procedure.
Do these steps:
1. From the temporary folder – Locate, and then double-click, the
“CReflash” filename or icon. The CReflash utility opens:
2. Enter your upload parameters information into CReflash:
a. Left-click in the “IP Address:” text box, and enter the default
Management IP Address.
b. Left-click in the “Local Filename:” text box. Then, click [Browse]
and navigate to the temporary folder created earlier. Click on the
firmware “bin” filename, and then click [Open]. The filename will
appear in the “Local Filename:” text box.
c. Make sure the drop-down list remains set to “bulk:”.
d. Click [Start] to begin the upload process. If the information was
correctly entered into CReflash, the utility displays an animated
progress bar at the bottom of the window, along with a series of
messages:
• “Opening FTP”
• “Sending data file to modem:”
• “Writing FLASH: # of #”
• “Success!”
3. When done, click [Cancel] to exit CReflash.
To Next Page
Loading...
