UT-4500 Series C- and Ku-Band Up Converters MN/UT4500.IOM / CD/UT4500.IOM
Table of Contents Revision 3
xii
8.7.2.3 TPE (Time Protocol Enable) ........................................................ 8–12
8.7.2.4 TPS (Time Protocol Server) ......................................................... 8–12
8.7.2.5 LRS (Local / Remote Status) ........................................................ 8–12
8.7.2.6 MAC (Media Access Control Address) ........................................ 8–13
8.7.2.7 IPA (IP Address) ........................................................................... 8–13
8.7.2.8 IPG (IP Gateway) ......................................................................... 8–13
8.7.2.9 SPA (Set Physical Address) .......................................................... 8–14
8.7.2.10 SBR (Set Baud Rate) .................................................................... 8–14
8.7.2.11 CON (Set LCD Contrast) .............................................................. 8–14
8.7.2.12 LCD (Set LCD Brightness) ............................................................ 8–15
8.7.2.13 SSM (Screen Saver Mode) .......................................................... 8–15
8.7.2.14 SST (Screen Saver Timeout) ........................................................ 8–15
8.7.2.15 VFD (VFD Brightness) .................................................................. 8–16
8.7.2.16 SRO (Set Reference Oscillator Tuning) ........................................ 8–16
8.7.2.17 SSA (Converter Slope Adjustment) ............................................. 8–16
8.7.2.18 RET (Equipment Type) ................................................................ 8–17
8.7.2.19 PNM (Part Number) .................................................................... 8–17
8.7.2.20 FRW (Legacy Firmware Information) .......................................... 8–17
8.7.2.21 FRM (Firmware Information) ...................................................... 8–18
8.7.2.22 IMG (Firmware Image) ............................................................... 8–18
8.7.2.23 AID (Application Identification) .................................................. 8–19
8.7.2.24 FRB (Force Reboot) ..................................................................... 8–19
8.7.3 Configuration Commands / Queries .................................................. 8–20
8.7.3.1 FRE (Frequency) .......................................................................... 8–20
8.7.3.2 IFF (IF Frequency) ....................................................................... 8–20
8.7.3.3 ATT (Attenuation) ....................................................................... 8–21
8.7.3.4 CLD (Cold Start) .......................................................................... 8–21
8.7.3.5 MUT (RF Mute) ........................................................................... 8–21
8.7.3.6 CMM (Configure Mute Mode) .................................................... 8–22
8.7.3.7 CRM (Redundancy Mute Mode) ................................................. 8–22
8.7.3.8 AFR (Auto Fault Recovery) .......................................................... 8–22
8.7.3.9 PGM (Program Pre-select) .......................................................... 8–23
8.7.3.10 DPS (Display All Pre-selects) ....................................................... 8–23
8.7.3.11 CLR (Clear Pre-select Configuration) .......................................... 8–24
8.7.3.12 SEL (Select Pre-select Configuration) ......................................... 8–24
8.7.4 Operating Modes ............................................................................... 8–24
8.7.4.1 RED (Redundant Mode) .............................................................. 8–24
8.7.4.2 ICT (Initialize Chain Command) .................................................. 8–25
8.7.4.3 SAM (Switching Automatic/Manual Mode) ............................... 8–25
To Next Page
Loading...
