Chapter 4 Drive System Wiring And Introduction
4.3.2 Regeneration Resistance Connection
If use the built-in resistor, please connect P and D( a 4 pins connector for built-in resistor
has been set by factory, so you can insert it to the terminal directly), as picture A showed.
When an external regeneration resistance is connected to the servo drive, the short circuit
between terminal P and D must be disconnected. Then the external regeneration resistance could
be connected between P and C, and leave N alone,as picture B showed.
Pic A Pic B
Precautions for braking resistor wiring:
Do not be less than the minimum allowable resistance of 25Ω, otherwise it
will cause a driver alarm or damage the driver;.
Please install the external braking resistor on non-combustible substances
such as metal.
To Next Page
Loading...
